Potential Application
4-Bolt brake clamp bolts (for ultimate weight saving only, maximum torque 3.5Nm)
Lever clamp bolt for Magura HS33 brake levers
Lightweight upgrade bolts such as these should always be used with care, we cannot accept responsibility for any damage caused by incorrect installation or misuse.
There are currently no questions relating to this product.
Based on 1 customer rating
£0.50
In stock
Product code: 14075
£185.00
£185.00
7 colours available
£185.00
£12.00
In stock
Technical InfoNew to trials? Then check out our product video guides for useful tips and technical advice
FacebookFollow us on Facebook for exclusive deals, promo codes and offers
Need some help?Have a question? No problem, call us on 01772 32 33 33 or get in touch via our contact page.
TartyBikes Ltd, Units 3-4, Club Street, Bamber Bridge, Preston, PR5 6FN
Web Design & Development by tame
Look good but are weak!
Posted by Cai
When used as Magura lever bolts these were fine, looked good and sved weight. But when I used them to clamp the Magura slaves it became obvious that these are too weak for the job, two of the heads came clean of when tightening them up - and I in no way overtightened the bolts as the slaves could still move a little. So I'd recomend these for area's that don't demand alot of clamping strength.
Reply from TartyBikes
Hi Cai - We don't recommend tightening these bolts above 3.5N/m as they can shear/break if tightened more. When installed using grease they tighten up nicely, certainly without causing any damage to the bolt. Sorry to hear you had problems with them!